Aquabee skimmer Cove i 200 pump: DC 5000 24 volts, 0-30 watts Dimensions: 25 x 32 x 56 cm, for the filter sump
The cove I 200 is the skimmer when it comes to absolute quietness.
The cove I 200 is a skimmer for operation within the filter basin.
We recommend the skimmer for saltwater aquariums from 400 to 1000 liters.
The ideal water level should be between 18 cm and 25 cm.
Technical data.
- Dimensions of the skimmer:
- Width 242 mm, length 320, height 555 mm
- tool-free dismantling
- The reactor tube can be dismantled very quickly using a bayonet screw connection
An additional 38 mm must be allowed for when removing the foam cup and the height of the skimmer for installation in the under-cabinet technology basin.
Technical data of the pump:
UP 5000 skimmer V24
- Electronic regulation in 10% steps
- 20 - 100% adjustable
- 24 volt protective extra-low voltage
- 10 volt interface
- 25mm pipe connections
- Pump can be separated from controller
- 24 volt protective extra-low voltage
- Power supply is included in delivery
- Power cable 1.80m control cable 3m
- Dry running protection function
- Switches back on to the previously set value after a power failure
- Power supply MEAWELL power supply 100-240V 50/60Hz
Scope of delivery :
- 1 x coveI 200 skimmer
- 1 x UP 5000 skimmer V24
- 1 x Spare Parts Set
- 1 x operating instructions for dispersant pump
- 1 x operating instructions for skimmer
Pump:
UP 5000 skimmer V24
The UP 5000 V24 skimmer is a new skimmer pump that was developed for the highest requirements in saltwater aquariums. The new 24 volt brushless DC motor enables absolute smooth running and offers the highest level of safety thanks to the protective extra-low voltage. The maximum output is 1200 l/air per hour, with only 30 watts. The controller allows the air output to be adjusted from 20 to 100% in 10% increments. The needle wheel and the Venturi nozzle are also designed to run absolutely effectively and quietly in order to meet the highest demands. The pump can be dismantled without tools using the bayonet lock on the rotor housing. The shaft and plain bearing bushes are made of the hardest, long-lasting ceramic. The age-resistant and vibration-damping silicone bushings in which the plain bearing bushings are enclosed ensure very quiet running. We make the needle wheel from POM. The plastic POM has a much higher strength than other plastics. This makes the needle wheel extremely durable.