Aquabee skimmer Cove i 250 pump: DC 8000 24 volts, 0-50 watts dimensions: 29 x 38 x 60 cm, for the filter sump
The cove I 250 is the skimmer when it comes to absolute quietness.
The cove I 250 is a skimmer for operation within the filter basin.
We recommend the skimmer for saltwater aquariums from 1000 to 1400 liters.
The ideal water level should be between 18 cm and 26 cm.
Technical data.
- Dimensions of the skimmer:
- Width 282 mm, length 375, height 600 mm
- tool-free dismantling
- The reactor tube can be dismantled very quickly using a bayonet screw connection
An additional 38 mm must be allowed for when removing the foam cup and the height of the skimmer for installation in the under-cabinet technology basin.
Technical data of the pump:
UP 8000 skimmer V24
- Dimensions of the pump (with pipe connections): length: 186mm height; 152mm width: 100mm electronic
- Control adjustable in 5 watt steps 5 - 50 watts
- 24 volt protective extra-low voltage
- 10 volt interface
- 32mm pipe connections
- Pump can be separated from controller 24 volts
- Power supply is included in delivery
- Power cable 1.80m control cable 3m
- Dry running protection function
- Switches back on to the previously set value after a power failure
- Power supply MEAWELL power supply 100-240V 50/60Hz
Scope of delivery :
- 1 x cove I 250 skimmer
- 1 x UP 8000 skimmer V24
- 1 x Spare Parts Set
- 1 x operating instructions for dispersant pump
- 1 x operating instructions for skimmer
Pump:
UP 8000 skimmer V24
The UP 8000 V24 skimmer is a new skimmer pump that was developed for the highest requirements in saltwater aquariums.
The new 24 volt brushless DC motor enables absolute smooth running and offers the highest level of safety thanks to the protective extra-low voltage.
The maximum output is 2000 l/air per hour (with cove air intake nozzle), with only 50 watts. The controller allows the air output to be adjusted from 0 to 50 watts in 5 watt increments.
The needle wheel and the Venturi nozzle are also designed to run absolutely effectively and quietly in order to meet the highest demands.
The pump can be dismantled without tools using the union ring on the rotor housing. The shaft and plain bearing bushes are made of the hardest, long-lasting ceramic.
The age-resistant and vibration-damping silicone bushings in which the plain bearing bushings are enclosed ensure very quiet running. We make the needle wheel from POM. The plastic POM has a much higher strength than other plastics. This makes the needle wheel extremely durable.